Design review — control paths and I/O (sequencer logic/memory, IO, bus tester, backplane, video) — 2026-09-21¶
Section 5 of the 2026-09-21 control-paths and I/O review: the backplane v2.0, finding 5.1. The other cards' sections ("above" and "below" in the original), the cross-card notes and the summary:
hardware/reviews/control-io-2026-09-21.md.
Second pass after the mechanical one in mechanical-2026-09-21.md. Read from the KiCad netlists (reports/netlist.net, pin
types from the Eagle symbols), chip values from the Eagle boards, the firmware that drives the ATmegas
(embedded/bus-tester/bus-driver, embedded/sequencer-card/sequencer4) and the microcode generator
(firmware/microcode/ucode-generator2). Gate pin-outs were checked against the symbol pin functions (I0/I1/O for
7400/08/32, O/I/I for 7402; 74175/74/192/244/374 pin functions as printed in the netlist).
Every finding: the trace (ref.pin -> net -> ref.pin, chip types), the failure scenario, severity (HIGH = stops the card / damages parts, MED = unreliable or latent, LOW = housekeeping), and how to confirm it on the bench. Already-known items (BACKLOG.md, video README) are not repeated except where a new detail changes them. Report only; no redesign.
Scripts used (not committed): a netlist dumper (parts + nets with pin function/type), an SV1/SV2 pin-by-pin comparator, a bus-driver-table-vs-tester-wiring check and a microcode-bit-vs-RAM-wiring check; the results of the three checks are in the "checked, no issue" lists below.
5. Backplane v2.0 (hardware/bus/backplane/kicad/v2.0)¶
Checked, no issue¶
- 8 × FABC96S; every one of the 86 signal pins is a straight 8-member net (nothing else on any of them): no pull-ups, no termination, no series resistors.
- Power: 5V on A2/B2/C2/A31/B31/C31 and GND on A1/B1/C1/A32/B32/C32 of every slot (6 + 6 pins per slot), eight electrolytics C1–C8 (one per slot, value blank), R1/PWR0 LED, single wire-pad entry for 5V and GND.
5.1 LOW — no pull-ups anywhere on the bus¶
Consequence for the scenarios above: whenever the logic card's 374/244s are off (READY low for ~54 s at every boot; tester holding -BUS-EN high) the control lines float. LS inputs read that as high, which is inactive for all the active-low strobes (that is why the memory and IO cards sit quietly during the microcode load), but the active-high lines (REG-*-ID, ADDR-REG-ID, IO-ADDR, ALU0–3, BR-COND, OUT, IN) are undefined and the 4077/CMOS inputs on other cards see mid-rail. Not a fault of the backplane as drawn; a pull-up bank on a future revision is the usual answer.
Last updated 26 October 2026