Skip to content

Design review, datapath cards (control-path pass) — 2026-09-21

One card of the 2026-09-21 datapath review: the Mem Register 1.0. The other cards, the system-level items S1-S3 and the summary: hardware/reviews/datapath-2026-09-21.md.

Second pass after mechanical-2026-09-21.md (mechanical). Cards: ALU v3.2, Index Register 1.1, Memory v1.3, Mem Switch 1.1, Mem Register 1.0. Method: every select / enable / strobe / clock / reset net was traced pin-to-pin from kicad/<ver>/reports/netlist.net (pin names and types from the Eagle symbols) with chip types from the Eagle .brd, and checked against the way the sequencer microcode actually drives the bus (firmware/microcode/ucode-generator2/), because several hardware choices only work under a microcode convention. Signal polarity: - prefix = active low. Gate delays quoted are LS-TTL typicals from the datasheets in docs/datasheets/.

Severity: HIGH = would stop the card working or damage parts; MED = unreliable / depends on a convention that is not enforced by hardware; LOW = housekeeping or documentation.


Mem Register 1.0 (hardware/cards/mem-register/kicad/v1.0/)

The review traced the two bring-up cards together, in one section, "Mem Switch 1.1 and Mem Register 1.0": hardware/cards/mem-switch/reviews/v1.1-datapath-2026-09-21.md. B1 (both cards overlap low RAM, see M4) and the "Checked, no issue (bring-up cards)" list, which covers this card's write path, apply to this card; B2 is the Mem Switch's alone.

Last updated 26 October 2026